Full System Cleaning in Frisco, TX

Every visit starts with

Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents

Worth knowing

That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.

Styles & brands we work with

‹

›

Before & after – our own jobs

‹

BeforeAfter

BeforeAfter

BeforeAfter

›

Full System Cleaning in Frisco, TX

Full system cleaning covers every component your forced-air system moves air through: the supply and return duct runs, the main trunk lines, the air handler cabinet, the blower compartment, and every register grille in the home. In Frisco, where new construction and rapid subdivision growth mean homes regularly sit with builder-grade dust, drywall particulate, and fibrous insulation fragments locked inside the ductwork from day one, a partial clean leaves the problem half-solved. A full system cleaning resolves it completely – and CleanRun documents every duct run with camera photos before and after so you can see exactly what changed.

If you’ve been looking at Air Duct Cleaning in Frisco as a service category, full system cleaning is the version of that service that accounts for the entire airpath – not just the registers you can see from the hallway. Call us at (940) 290-8552 and a live person will answer, give you a written price before any work is scheduled, and explain exactly what the job covers at your address.

When You Need Full System Cleaning

Not every residential duct cleaning needs the same scope. Here are the situations where a full system cleaning – rather than a spot clean or register-only service – is the right call:

• You bought a home built between 2015 and 2023 in Frisco and it’s never been cleaned. New construction in Frisco neighborhoods like Phillips Creek Ranch, Edgestone, and Hollyhock generates significant drywall dust and fibrous debris during the build phase. That material gets pulled into the duct system before the filters are ever seated properly, and it stays there. The camera inside a first-floor return on a four-year-old home in these subdivisions routinely shows a grey-brown film coating the interior liner.
• Your allergy symptoms are noticeably worse indoors than outdoors. Frisco sits in Collin County, where cedar and oak pollen counts run high from December through April and again in the fall. When pollen and fine particulate accumulate inside duct runs, the HVAC system recirculates them every time the fan kicks on. A full system cleaning removes the reservoir, not just what’s near the register face.
• You’ve had recent renovation work – flooring, drywall, or a kitchen update. One remodeled kitchen in a Frisco home near Stonebriar Centre can push enough fine silica and adhesive particulate into the return side of the system to coat the blower wheel and reduce airflow measurably. The blower compartment and air handler cabinet are part of a full system cleaning in a way they’re not part of a basic duct service.
• Some rooms are noticeably hotter or cooler than the rest of the house. This is often described as a duct balance problem, and sometimes it is. But an equally common cause is debris accumulation at an elbow or transition fitting that has partially blocked airflow to a specific zone. The camera work that’s standard on every CleanRun job identifies this before we attribute it to something else.
• There’s a visible dust line at register grilles within a day or two of cleaning them. If you’re wiping registers weekly and the ring of grey-brown residue comes back fast, the duct liner itself is shedding debris. That’s a full-system issue – the supply side, the trunk, and the return plenum all need attention, not just the register covers.
• The home has never had a documented cleaning with a written job record. Previous owners may have had “duct cleaning” done. Whether that was a professional negative-pressure extraction job or a shop vac with a long hose is usually unknowable without camera documentation. A full system cleaning with a documented photo record establishes a verifiable baseline for the home’s maintenance history.

Our Full System Cleaning Process

The steps below describe what actually happens on-site. Each one applies to every full system cleaning CleanRun performs in Frisco – no steps are skipped based on job size or price point.

1. Pre-job walkthrough and camera inspection of accessible duct runs.
   Before a single piece of equipment comes off the truck, the technician walks the home with you, identifies every supply register, every return grille, the air handler location, and the trunk line routing. A camera passes through the accessible duct runs and the images are captured as the “before” portion of your Documented Photo Record. What the camera shows is the starting point for the written scope – not an assumption based on home age or square footage.
2. Written price confirmed before work begins.
   After the inspection, you receive a written price for the full system cleaning. Under Haven Standard Clause 1, no work starts until you’ve seen that number in writing and agreed to it. There is no “we’ll know when we get in there” pricing at CleanRun. The written price covers the complete scope identified during inspection, including the air handler cabinet and blower compartment.
3. Negative-pressure extraction across the full duct system.
   Negative-pressure extraction means the technician attaches a high-capacity vacuum unit – equipment from Nikro or Abatement Technologies depending on the system configuration – to the trunk line, creating a sustained draw that pulls loosened debris toward the collection point rather than pushing it further into the system or out into the living space. Every supply run and every return run is agitated with a Rotobrush-system rotary brush that scrubs the interior liner while the negative pressure holds. This is the distinction between a documented cleaning and vacuum noise at the register face.
4. Air handler cabinet and blower compartment cleaning.
   The air handler cabinet houses the evaporator coil housing, the blower wheel, and the plenum connections – the plenum being the distribution box that feeds air into the trunk lines. A blower wheel that’s accumulated a uniform layer of dust and fine debris loses measurable efficiency; it also becomes a redistribution point that recontaminates cleaned duct runs within weeks. CleanRun cleans the blower compartment and the accessible interior surfaces of the air handler cabinet as part of every full system cleaning. If the evaporator coil face shows debris accumulation, that’s noted in the written scope and photographed separately.
5. Register grilles cleaned and reinstalled; system run-check performed.
   Every register grille comes off, gets cleaned of accumulated surface debris, and goes back on correctly. After reinstallation, the system runs for a short cycle while the technician checks airflow at each register. Significant airflow differences between registers after cleaning get flagged in the job record for follow-up – this is where a full system cleaning sometimes surfaces a duct balance or duct integrity issue that was masked by debris.
6. Post-job camera pass and Documented Photo Record delivered to you.
   The same camera that shot the before images passes through the duct runs again. The before-and-after photo record is assembled and delivered to you as a standard job deliverable – not an add-on, not something that requires a follow-up request. Every job CleanRun has run since 2013 has included this documentation. You can verify what was done, show it to a future buyer, or use it to compare against the next cleaning years from now. The 365-Day Done Right Promise backs the work in writing: if it’s not right, we make it right, no manager approval required.

Before

After

Full System Cleaning Pricing in Frisco

Full system cleaning in Frisco typically runs between $349 and $649 for a single-system residential home, depending on the factors below. Homes with dual HVAC systems – common in larger Frisco properties in Starwood, Newman Village, and the Trails of Frisco – typically run $599 to $950 for both systems cleaned in a single visit.

What moves the number up or down:

• Register count: More duct runs mean more linear footage of agitation and extraction time. The written price reflects your actual count, not a round number estimate.
• Debris load: A new-construction home in Frisco that’s never been cleaned carries more material than a ten-year-old home that was cleaned four years ago. The pre-job camera inspection determines this – it’s not an assumption.
• Duct type and access: Flex duct systems common in Frisco homes built after 2010 clean differently than older sheet metal. Tight attic routing or a horizontal air handler in a low-clearance space affects time on the blower compartment portion of the job.
• Second system: If the home has a dedicated system for the second floor or a casita, adding the second system to the same visit costs significantly less than scheduling a separate trip.

Every price CleanRun gives is written down before work starts – Haven Standard Clause 1 makes that non-negotiable. If you have a written estimate from another company, bring it: a Free Second Opinion means we put our number next to theirs in writing at no charge. Call (940) 290-8552 for a same-day written quote.

FAQs – Full System Cleaning

How is a full system cleaning different from a standard duct cleaning?

A full Air Duct Cleaning includes the air handler cabinet and blower compartment in addition to the duct runs and registers – a standard or “basic” duct cleaning often covers only the duct runs, leaving the blower wheel and plenum connections untouched. In practice, a blower wheel that hasn’t been cleaned redistributes debris into freshly cleaned ducts within a few weeks. CleanRun’s full system cleaning treats the complete airpath as a single unit because that’s what it is. Call (940) 290-8552 and we’ll explain exactly which components are included before you agree to anything.

How long does a full system cleaning take in a typical Frisco home?

Most single-system homes in Frisco take between two and four hours from the pre-job camera inspection to the final photo record handoff. Larger homes or homes with a heavy debris load from construction or a renovation project run closer to four to five hours. A dual-system home cleaned in a single visit typically takes five to six hours. The time estimate is part of the pre-job conversation – you’ll know what to expect before the technician starts.

Do I need to do anything to prepare before the technician arrives?

Clear access to each register grille and to the air handler location – typically in a utility closet, attic, or garage in most Frisco homes. Pet crating or containing pets in a separate room helps the technician move through the house efficiently. There’s no need to move furniture off every register; the technician works around normal furnishings. If there’s a specific area of the home with restricted access, mention it when you call so the written scope can account for it accurately.

Is the 365-Day Done Right Promise included on a full system cleaning?

Yes – the 365-Day Done Right Promise applies to every job CleanRun performs, including full system cleaning in Frisco. If something isn’t right after the crew leaves, CleanRun makes it right – that’s a written commitment on the job record, not a call-center policy subject to interpretation. The Documented Photo Record gives both sides a clear, objective reference point: before images and after images, every duct run, delivered to you the same day. Call (940) 290-8552 with any questions about what the promise covers on your specific job.

What You Get When the Truck Leaves

After a full system cleaning in Frisco, you have three things in hand: a written record of what was found before the work started, a set of after-images showing the interior of every duct run that was cleaned, and a written 365-Day Done Right Promise attached to the job. That documentation is useful beyond the day of the visit – it’s a record you can reference when you sell the home, reference against the next cleaning, or show to an HVAC technician who wants to understand the system’s maintenance history.

CleanRun has been building that kind of documented job record since 2013, across more than 52,000 homes. Every one of those jobs started with a written price and ended with a photo record. The equipment used – Rotobrush agitation systems, Abatement Technologies extraction units, Honeywell and Aprilaire filtration components where applicable – is professional-grade and verifiable by name. Tomas Reyes leads the operation, and every technician arriving at your door in Frisco is background-checked, uniformed, and identified by name in advance under Haven Standard Clause 3.

For homeowners in Frisco who’ve done the research and want a job that can be verified rather than trusted on faith, full system cleaning with CleanRun is the service that matches that standard. If you want to see what that looks like at your address specifically, call (940) 290-8552. A live person answers every call, a written price follows the inspection, and the work doesn’t start until you’ve agreed to the number.

Written by Tomas Reyes, Owner at CleanRun Air Duct Cleaning Frisco, serving Frisco since 2013.